Furnace Installation in Airdrie

It depends on the efficiency tier, the output your home actually needs, and what's already in your mechanical room — and we won't quote it over the phone, because a number given sight-unseen changes on install day.

The main variables: the unit itself (entry single-stage through premium modulating), whether it's a straight swap or the ductwork needs rework, and whether the venting or gas line has to change.

We come out, run the heat-loss calc against Airdrie's −35°C design temperature and wind exposure, and give you the model, the AFUE rating, the full scope, and the all-in price in writing at no charge. Financing is available to spread the cost.

Same design temperature, harsher real conditions. Airdrie sits north of Calgary on open prairie at higher elevation — windier year-round, with far less of the built-up shelter Calgary neighbourhoods have.

Wind strips heat off a building faster than still air at the same temperature, so real-world heat loss in Airdrie runs higher than the −35°C number alone suggests. A furnace sized off a generic chart is often undersized for that exposure and runs flat out on the coldest, windiest nights without holding the setpoint.

We size for the exposure, which sometimes means a bit more output than a chart would call for.

Age and the nature of the fault decide it. Under about 12 years with a single failed part — igniter, flame sensor, capacitor — repair it; the furnace has years left, and that's a job for our Airdrie furnace repair team.

Over 18-20 years with a major failure like an ECM blower motor or control board, replacement is usually the smarter spend, because the rest of the unit is the same age. And a cracked heat exchanger means replacement at any age — it's a carbon monoxide safety issue, not a cost calculation.

We'll assess yours and tell you straight which side of the line it's on.

A straight replacement is usually a single day, roughly 6-10 hours. Installs that need a gas line upsize, a new vent run, or ductwork changes can run into a second day.

We give you the timeline in writing with the quote, and we don't leave an Airdrie home without heat overnight in winter.

Yes. Furnace installations require a permit and an inspection. FlameTech pulls the permit and books the inspection as part of the job — it's not something you need to chase.

For a long, cold, windy heating season, a high-efficiency condensing furnace (95%+ AFUE) almost always pencils out. It extracts extra heat from exhaust gases that an older 70-80% unit sends up the vent, and across Airdrie's seven-month heating season the gas savings add up.

Within the high-efficiency tier, single-stage, two-stage, and modulating units trade upfront cost for comfort and efficiency. We walk you through which fits your home and how long you plan to stay, then size it for your lot's exposure.

Yes — new installs, full replacements, and additions. For a new build or addition the heat-loss calc is even more important, since there's no existing system to reference, and we size against Airdrie's design temperature and exposure from the plans and the finished envelope.